Overspending usually comes from a few targets or campaigns, not from all of them. Set a monthly ad budget from what your books earn, find the targets that take most of the spend without orders, and cap bids before you cut budgets, so your profitable ads keep running.
Last reviewed by the InteliAds team.
Set a budget from what your books earn
A sensible monthly budget is one your books can pay back. Start from your royalties: what did your books earn last month in sales and page reads? If ads are new, set a test budget you can afford to lose while learning, and treat it as tuition.
Amazon charges for clicks, and its daily budgeting policy lets spend on a single day go above the daily budget while the month stays within the average daily budget. So watch monthly totals, not single days.
Sort every keyword, product target and auto target by spend over the last 30 days. In most accounts, a small share of targets takes most of the spend. For each of the top ones, note orders and ACOS against break-even.
Three groups appear: big spenders with no orders (cut), big spenders above break-even (lower bids), and big spenders below break-even (keep; these earn their spend).
What to do with each high-spend target
Target
Signal
Action
High spend, no orders
Pure loss
Pause or negate
High spend, ACOS above break-even
Selling at a loss
Lower bid 10-20%
High spend, ACOS below break-even
Profitable
Keep; consider more budget
Auto and broad campaigns: the usual leak
Auto campaigns and broad-match keywords are where spend most often runs ahead of sales, because Amazon decides which searches and product pages they match. That is their job during discovery, but left alone they keep paying for the same poor matches.
Keep discovery campaigns on smaller budgets and lower bids than your proven manual campaigns. Each week, move search terms that sell into a manual campaign and add the ones that only spend as negatives. Once a book has a solid manual campaign, its auto campaign can often run on a much smaller budget.
Check for overlap too. If the same keyword runs in three campaigns, you bid against yourself and spread data thinly. Keep each target in one place where you can judge it.
Cap bids before cutting budgets
Cutting a campaign's daily budget stops all its targets, good and bad, earlier in the day. Lowering bids on the expensive, unprofitable targets stops the leak while the good ones keep running. Use budgets as a ceiling and bids as the control.
Also check placement adjustments. A large top-of-search increase raises cost per click on every target in the campaign. Remove it if top-of-search orders do not justify it.
Where InteliAds automates spend control
BidBot reviews the targets with the highest spend as their own priority group, so the expensive ones are checked first. Safe mode limits how many bid changes it makes per day and waits 48 hours between changes to the same target; you can also set it to lower bids only.
InteliAds Rules are IF/THEN rules that run every hour. Conditions can use impressions, clicks, CTR, CPC, spend, orders, sales, ACOS, ROAS and conversion rate over a date range. Actions include pause, enable, set, raise or lower a bid, set a daily budget, change a placement adjustment, add a search term as a negative, or add it as a new target. Dry Run shows what a rule would change before it touches Amazon, and every change can be reverted.
Spend-control rules many authors use: pause a keyword when spend in the last 14 days exceeds your royalty for two sales with 0 orders; set a campaign's daily budget lower during quiet months. Preview each with Dry Run.
Write down last month's KDP earnings and ad spend.
Set a monthly ad budget your books can pay back.
Sort targets by 30-day spend and mark orders and ACOS.
Pause high-spend targets with no orders; negate their search terms.
Lower bids on high-spend targets above break-even.
Review placement adjustments.
Then, if total spend is still too high, reduce daily budgets.
Worked example (illustrative numbers)
Invented figures. An author's books earned $900 last month; ads cost $750. Sorting by spend, 15 of 180 targets took $410. Of those, 5 had no orders ($140), 6 were above break-even ($190) and 4 were profitable ($80).
Pausing the 5 and lowering bids 15% on the 6 cuts roughly $140 plus some of the $190 without touching the 4 profitable targets. Next month's spend lands near $560 with similar orders, and no campaign budget was cut.
Frequently asked questions
Why does Amazon spend more than my daily budget?
Amazon's daily budgeting policy lets single days go over the daily budget while the month stays within the average. Watch the monthly total.
Should I lower my daily budget to spend less?
Lower bids on unprofitable targets first. Cutting budgets also stops your profitable ads.
How much should I spend on KDP ads?
An amount your books' royalties can pay back. Start with a test budget you can afford while learning.
Can InteliAds stop ads from overspending?
It can lower bids and pause targets automatically with Rules or BidBot, within limits you set. Budgets themselves are still enforced by Amazon.
Amazon and KDP rules change; check the linked help pages before making decisions. Worked examples use illustrative numbers, not results from real accounts.